New build insurance providers state that the cavity needs to be a minimum of 25mm in England and Wales, and 50mm in Scotland, Northern Ireland and Republic of Ireland. For Indian climatic conditions, the best option would be to have skylights that open Skylight Design Principles We do not recommend directly painting as the jointing is likely to show and be unsightly. For best results, tape and joint the boards using Knauf AQUAPANEL ®Joint Filler and AQUAPANEL ®Tape. and then apply Knauf Interior Skim and apply the paint (by others) to this. Direct splash zones should always be tiled.

Knauf AQUAPANEL ®Joint Filler - Grey, AQUAPANEL ®Tape, AQUAPANEL ®Screws (dependent on framework type), and exterior thin render coat system (incorporating a modern thin basecoat and mesh, and a finish coat). LMCC is an Office 365 customer and invested in PowerApps, Power Automate, Office 365 and SharePoint. Bing Maps pricing and the connectors to PowerApps and Power Automate made it the right choice.A wide variety of our skylight products and configurations have been subjected to the Hurricane Rating and Bomb Blast Resistant Test. Our skylights held up to Hurricanes Luis and Lenny — both extreme hurricanes with winds in excess of 225 miles per hour, ultimately proving our creations are strong even in the toughest of circumstantial conditions. Besides tests, our durability shows with over 40 years of successful installation projects. Knauf AQUAPANEL ®Cement Board Outdoor is A1 rated to EN 13501; it is therefore non-combustible and will not allow fire to spread along its surface. However, as the board is installed over a drained and ventilated cavity, any fire may get behind the cladding. A timed fire rated walling system would be accomplished from the sheathing layer inwards. Cavity fire stopping should be discussed with the passive fire stopping specialists on the scheme. Knauf recommend that the boards are installed with a 3 to 5mm gap all around the boards, and all joints are taped and jointed using Knauf AQUAPANEL ®products (this must be done for soffit applications). If the thin coat render basecoat and mesh layer is going to be applied within 4 to 6 weeks of the boards being installed, the tape and jointing application can be omitted, but the basecoat must be applied into the gaps prior to application of the basecoat and mesh layer. Yes, the cladding must be ventilated at the head of the cladding with a minimum gap of 10mm between the top of the rendered cladding and the structure above (soffit box, coping etc.). This allows any warm moist air to escape from the cavity.

Does the cross battened system need to be horizontal to the structure and vertical behind the Knauf AQUAPANEL ®Cement Board Outdoor? Knauf AQUAPANEL ®Cement Board Indoor is perfect for rooms housing swimming pools, spas and saunas, wet rooms, kitchens, laundries, bathrooms, changing rooms, and anywhere where high levels of moisture are present including underground cellars and stores. Ideal to create curved surfaces and wave effects. It allows tiles that require high pressure washing to be used in areas such as food handling. We had a chance to connect with Dave Chennault, Partner at SkyLite Systems, to learn more about the application and their experience building with Bing Maps.

SkyLite Systems is an award-winning Microsoft partner focused on delivering commercial and custom solutions built around SharePoint and Office 365. Presented with the challenge to develop an agile solution for the Labor Management Compliance Council (LMCC) to complement their SharePoint Case Management tool, SkyLite Systems leveraged Office 365 and Bing Maps to deliver a mobile application that is robust, cost-effective and location aware. No, this board should only be used for internal applications. Knauf offers Knauf AQUAPANEL ®Cement Board Outdoor (which is freeze thaw tested) for exterior uses. We recommend you use a cement-based flexible tile adhesive (Class C2 / S1 according to EN 12004-12002). If you need better waterproofing than just the tiles, use a waterproof adhesive, provided it is cement based.

Low cost, speed of development, deep integration with PowerApps, Flow and Office 365, quality of results and capability.Knauf AQUAPANEL ®Cement Board SkyLite can be used both as a ceiling in interior humid or wet environments where water vapour and high temperatures up to 70 °C occur, and as an exterior soffit, allowing the interior ceiling design theme to be continued through windows as a soffit under deep external roof overhang. Can Knauf AQUAPANEL ®Cement Board SkyLite be used as an alternative to Knauf AQUAPANEL ®Cement Board Outdoor on walling surfaces?

To get more details about the LMCC’s solution, read the customer story on Microsoft Tech Community. What was the previous process for entering a new case? How has including Bing Maps in the app helped?

Skylite Systems Serves The Following Areas

How long can the Knauf AQUAPANEL ®Cement Board Outdoor be left exposed before I should render them? What we had before was time consuming, and the Field Investigators had to use different components to take the picture, add notes, and upload. With the mobile app SkyLite created, it’s basically all in one. Instead of the FIs having to write everything, they just fill in fields, which makes it easier to add to a current project and/or create a project. For example, the automatic GPS of a project. The app locates the project, and the FI just has to make corrections, if there are any,” says Monika Almada, Labor Compliance Officer with the LMCC. Knauf AQUAPANEL ®Cement Board Outdoor provides a solid dry base that can withstand the extreme weathering effects of wind, rain and snow. Once taped and jointed, it can be left unfinished for up to 6 months, making use of the smallest windows of opportunity to ocmpletely close the external envelope, maximising the efficiency of the project schedule.